Click image to enlarge

• Save 15% on individual product prices. R.R.P. £144.11, YOU SAVE £21.62
• Enough to install a run of wire up to 180m
• Available with masonry rivets in either stone or grey colours
• Ideal for protecting masonry ledges, cornicing and parapets from pest seagulls
• All metal components made in stainless steel or copper

Specification

Kit Includes:

• 2 X 100m of Seagull Wire
• 60 X 180mm Single Headed Seagull Posts
• 60 X Gull Wire Micro Springs
• 200 X 1.0mm Copper Crimps
• 60 X Masonry Rivets
• 10 X Screw Pins & Plugs
• 1 X Crimp Tool
• 1 X 6.5mm Straight Shank Masonry Drill Bit

All Post & Wire Components are supplied in either stainless steel or copper

Usage

Maximum distance between gull wire posts = 3000mm (3m)

Gull wire should be spring-tensioned every 3000mm (3m) along its run, i.e. the wire should stop at a spring on each post and start with a newly crimped section of the other side of the post.

In doing so you are spreading the load evenly across the post system and avoiding spring overload

DO NOT thread the gull wire through the eyelets of the post and onwards to the next post, this will cause the system to sag and go out of shape.

The system should be counter-tensioned at the end of each run using the screw-pin and plugs provided. To avoid sagging of the system DO NOT use springs in the counter-tension wires,

Instructions and Technical Guide

Post and Wire System Technical Specification